Welcome to the Kramer Forum
http://kramerforumz.com/

Focus 3000: Matsu or ESP?
http://kramerforumz.com/viewtopic.php?f=8&t=1429
Page 1 of 1

Author:  RoteGitarre [ Wed Sep 13, 2017 10:29 pm ]
Post subject:  Focus 3000: Matsu or ESP?

I just bought a non-tilt pointy Focus 3000 and was curious if it was built by Matsu or ESP. I have a couple of tilt points and know that they were made by ESP (both '87 models), but wasn't sure about the earlier non tilt guits.

Also, the OFR is marked "Made in Germany", and my other two are "Made in W. Germany". Possible replacement, or did the W. Germany and Germany get used interchangeably?

Final note: When did the forum reboots again? Haven't been on in a couple of years and found that my username was deactivated and the name had a "z" added.

Sent from my XT1585 using Tapatalk

Author:  sixstring [ Thu Sep 14, 2017 8:23 am ]
Post subject:  Focus 3000: Matsu or ESP?

Yep new forum, old one got shut down by old proprietor.
Good to see you here.
Pointy 3000 is ESP. :worthless
Early Floyd's, tuners & nuts were stamped W.Germany.

Author:  KickstartMyHeart [ Thu Sep 14, 2017 8:25 am ]
Post subject:  Focus 3000: Matsu or ESP?

The MiG one should have been manufactured after 1990 (re-unification with the GDR).

This KF is a new place since George didn´t want to run and fund the old place but didn´t want to hand it over to a new admin either. Tony build this KF on the fly last year in August and did a great job in running this show.

Author:  RoteGitarre [ Thu Sep 14, 2017 9:28 am ]
Post subject:  Re: Focus 3000: Matsu or ESP?

Ok, may just be a replacement trem then. The knife edges are in great shape, but it has the usual corrosion issues. Ought to be able to clean her up nicely. Needs a fret level and some pickups, but should fit in nicely​ with the rest of the herd.

Sent from my XT1585 using Tapatalk

Page 1 of 1 All times are UTC-05:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/